©Microcontroller café & Checkpoint LAB MC68HC705E6 EEPROM PROGRAMMER User’s Guide
5
Table 1
18. Power LED POWER LED Red color led
19. Read/Write LED READ/WRITE LED Red/Green colour led
14. Ready/Error LED READY/ERROR LED Red/Green colour led
8. Ver. LED VERIFY LED Green colour led
1. RST RESET button System reset (AU mode)
2. RD READ button Read target MCU (AU mode)
3. WR WRITE button Write target MCU (AU mode)
4. VER VERIFY button Verify target MCU (AU mode)
5. JP3 MC68HC705E6 Mounted; JP4-JP10 left open
5. JP4 MC68HC05E6 Mounted; JP3,JP5-JP10 left open
5. JP5 MC68HC705P3 Mounted; JP3,JP4, JP6-JP10 left open
5. JP6 MC68HC05P3 Mounted; JP3-JP5, JP7-JP10 left open
5. JP7-JP10 Reserved (don’t care) Reserved (don’t care)
6. JP11 UPDATE jumper Normal operate - mounted
7. JP12 PC/ AU jumper PC – unmounted; AU - mounted
9. IIC Ext. 4 – pins IIC connector 1-+5V; 2- GND; 3- SCL; 4 –SDA
10. IIC mem. 8 – pins socket AT24C02 IIC memory
11. Target IC socket 28 – pins socket MC68HC7(05)E6/P3 IC socket
12. B-OFF Beeper OFF jumper Normal operate - mounted
13. Beeper Error message speaker 3 times beep – error occured
15. Power jack DC input jack + 12 V DC supply voltage
16. Power connector DC input connector + 12 V DC supply voltage
17. Serial port Serial interface connector PC serial interface
Installing MC68HC705E6 Programmer control software and hardware:
Navigate CPL CD-ROM : “Install Software” > “Install MC68HC705E6
Programmer”, then execute “Setup.exe” file. Follow the setup wizard
Connect MC68HC705E6 Programmer to the power supply source
(12-14 V >=300 mA)
Attach MC68HC705E6 Programmer to PC serial port
Make sure that "UP" jumper is mounted (normal operate position) and “PC” jumper
is unmounted for serial port control or is mounted for “AU” mode (autonomous
mode), if “AU” jumper is mounted pay attention to jumper position ( Table 1 )
Install target device into the target socket, notice the orientation of the device, first
pin marked ( Figure 1 )
Turn ON power supply source, power LED becomes lit ( red colour )
MC68HC705E6.exe control software can be started, if “PC” jumper is unmounted.
Otherwise, if “AU” jumper is mounted, M68HC705E6 Programmer will remain
in autonomous mode
Table 2
Operation mode
AU (Autonomous mode)
PC (Personal computer)
mode
PC jumper
- short
- open
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais